Capture the heat
Cold plates bring coolant close to the chips. It carries heat back to a coolant distribution unit, where the heat exchanger connects the two loops thermally.

Meridian One / Water & Cooling
Our proposed cooling system keeps coolant moving in sealed loops, carrying heat away from the servers and releasing it to the air.
The annual estimate
For the proposed full campus, the current estimate for normal operations is approximately:
1.3 million
litres per year 1,300 m³
Mainly staff and welfare. This is a provisional planning estimate, with the final water balance to be confirmed. Initial system fills, fire-water storage and major maintenance refills are assessed separately.
About 42% of one Olympic-size swimming pool, per year.
How it works
Water-based coolant absorbs heat at the servers. A heat exchanger passes that heat into a separate facility loop. Outside, dry coolers release the heat into the air.
Cold plates bring coolant close to the chips. It carries heat back to a coolant distribution unit, where the heat exchanger connects the two loops thermally.
Fans move outdoor air across sealed dry-cooler coils. The proposed design uses no cooling towers, water spray or adiabatic assist.
Temperature, pressure, flow and fluid quality need monitoring. Initial filling and replenishment after maintenance or losses still require water.

Dry heat rejection
Recirculation keeps the coolant in use. Dry coolers are the part of the proposed system designed to avoid water evaporation for heat rejection.
Detailed design must confirm performance on the hottest days without switching to a wet cooling mode.
Watch the film
Watch the explainer
A closer look at Meridian One’s proposed water and cooling approach.
Visit our YouTube channelThe latest project water and cooling explainer gives approximately 1,300 m³ per year for normal operations, mainly staff and welfare, across the proposed five-phase campus on a 100 MW total-import design basis. This is a planning estimate, not measured consumption or a guaranteed maximum. Cooling make-up, staff numbers and the operating calendar need confirmation in the final water balance. One-off fills, fire-water storage and exceptional drain-down or refill events are assessed separately.
No. The loops need an initial charge of coolant and may need replenishment after maintenance or losses. Staff and welfare facilities also need water. The proposed combination of sealed loops and dry heat rejection avoids routine evaporative cooling; closed-loop circulation alone would not establish that.
For this comparison, an Olympic-size pool is 50 metres long, 25 metres wide and 2.5 metres deep: 3,125 m³. Dividing the annual estimate of 1,300 m³ by 3,125 m³ gives 41.6%, rounded to 42%. This compares a year’s estimated fresh-water demand with one pool’s stored volume.